‑‑jet_power_from_probe
In this section:
Syntax
‑‑jet_power_from_probe=[leave_on|switch_off]
Parameters
leave_onContinues to supply power to the target even after the debug session has been stopped.
switch_offTurns off the power to the target when the debug session stops.
For use with
The C-SPY I-jet driver.
Description
Use this option to specify the status of the probe power supply after debugging.
If this option is not specified, the probe will not supply power to the board.
Caution
Project>Options>Debugger>I-jet>Setup>Target power