Skip to main content

IAR Embedded Workbench for RH850 3.20.x

Setting up for debugging

In this section:

  1. Install a USB driver or some other communication driver, if your C-SPY driver requires it.

    For more information, see:

  2. Choose Project>Options>General>Target and make sure that the device you are creating the application for is selected.

  3. In the Category list, go to the Debugger>Setup page and select the C-SPY driver that matches your debugger system—simulator or hardware debugger system.

  4. In the Category list, click the appropriate C-SPY driver category and make your settings. For information about these options, see Debugger options.

  5. Click OK.

  6. Choose Tools>Options to open the IDE Options dialog box:

    • Select Debugger to configure the debugger behavior

    • Select Stack to configure the debugger’s tracking of stack usage.

    For more information about these options, see Debugger options and Stack options. See also Adapting for target hardware.

Now you are ready to start C-SPY.