Skip to main content

IAR Embedded Workbench for RISC-V 3.40

Debugger options

In this section:

Setting debugger options

Before you start the C-SPY debugger you might need to set some options—both C-SPY generic options and options required for the target system (C-SPY driver-specific options).

To set debugger options in the IDE:

  1. Choose Project>Options to display the Options dialog box.

  2. Select Debugger in the Category list.

    For more information about the generic options, see Reference information on general debugger options.

  3. On the Setup page, make sure to select the appropriate C-SPY driver from the Driver drop-down list.

  4. To set the driver-specific options, select the appropriate driver from the Category list. Depending on which C-SPY driver you are using, different options are available.

    C-SPY driver

    Available options pages

    GDB Server driver

    GDB Server: Setup

    GDB Server: Breakpoints

    C-SPY I-Jet driver

    I-jet : Setup

    I-jet : Interface

    I-jet : Breakpoints

    Third-party driver

    Third-Party Driver options

    Table 49. Options specific to the C-SPY drivers you are using 


  5. To restore all settings to the default factory settings, click the Factory Settings button.

  6. When you have set all the required options, click OK in the Options dialog box.